No.
Item
Qty
1
XZENT X-F270 device
1
2
IR remote control
1
3
Two-part metal mounting frame
(not required for series 8)
1
4
Self-tapping Philips screws
(not required for series 8)
4
5
10PIN adaptor cable for 4.2 channel line-out
1
6
6PIN adaptor cable for A/V monitor-in
1
7
12PIN adaptor cable cam power + video-in
1
8
4PIN adaptor cable A/V monitor-out
1
9
Microphone with 3m cable extension and 3.5 mm jack
1
10
Parking brake connection cable
1
11
Main wire harness ISO/DIN
1
12
SWC interface adaptor
1
13
FM antenna adaptor ISO/DIN
1
14
GPS-antenna with 90° angled connector and 3 m cable extension
1
15
Doublesided 3M self-adhesive pad for GPS antenna
1
16
Main device manual for X-F270
1
17
USB extension cable with 80 cm length (gray / black)
2
FIAT DUCATO SERIES 8
CAUTION
- The installation of the XZENT system should be carried out by an authorized installer. Specific knowledge and tools are required to do the installation. Incorrect
installation can cause damage to the vehicle and the XZENT system.
- Correct functioning can only be guaranteed when you use the XZENT original accessories included in the kit or optionally available. The XZENT system and the
original accessories must under no circumstance be modified or altered in any way. Inappropriate actions can cause damage to the vehicle and the XZENT system.
NOTE
- The target vehicle must factory configured with preinstallation for a radio system. The XZENT system is not compatible with vehicles that are equipped with an
OE radio or OE navigation system from the factory.
- This device installation manual applies to vehicle platforms appearing in the above compatibility list, and in a condition as offered by the respective vehicle
manufacturer. Deviating equipment and specific adjustments to battery-, charging systems and power harness layout implemented by the given motorhome
manufacturer brand are not taken into account in these installation instructions. Please contact the relevant motorhome manufacturer.
- The XZENT system is equipped with an integrated DAB+ receiver. To make use of this you will need a suitable DAB antenna (not included in kit) that must be
connected to the XZENT system. If vehicle is equipped with ex-work OE DAB antenna, a FAKRA> SMB adapter is required for connection.
- In order to obtain better radio reception, it is recommended to equip the vehicle with an active antenna system (FM / DAB).
- If the target vehicle is equipped with a resistor based multifunction steering wheel, no additional accessories are needed to support the steering wheel remote
control functions. (See step 8. for Bluetooth telephony function details)
- Software updates to the XZENT system are installed with a USB memory device. Therefore when fitting the system make sure that the USB connection of the
XZENT system will still be accessible later (installation of USB extension cable for USB-1).
- If you have questions or problems relating to the XZENT system, please contact the dealer from whom you purchased it.
THE KIT INCLUDES
TOOLS REQUIRED
- Torx screwdriver T25
- Phillips screwdriver
- Dismanteling tool (See step 2.)
