1
INTRODUCTION
Thank you for choosing XYTRONIC LF-853D Multi-Function S.M.D. Rework Station. This
unit is the best tool for repairing work, combination with XYTRONIC LF-852D and LF-8800 which
is specially designed for lead free soldering/desoldering, surface mount devices with temperature
controlled hot air. The “3 in one” design ,save your working space. Please read the operating manual
carefully to maximize the advantages of using your new LF-853D multi-function SMD rework
station and keep this manual readily accessible for future reference.
【
【
【
【
WARNING
】
】
】
】
and
【
【
【
【
CAUTION
】
】
】
】
:
:
【
ELECTRICAL SHCOK
】
Warning and Caution are positioned at critical points in the manual to draw the user’s
attention to significant safety concerns. Be sure to comply with the following warnings and
cautions for your safety.
This appliance is not intended for use by children or other persons without assistance or supervision
if their physical, sensory or mental capabilities prevent them from using it safely. Children should be
supervised to ensure that they do not play with appliance. Failure to observe the safety regulation
will result in a risk of life and limb. The manufacturer shall not be liable for damage resulting from
misuse of the unit or unauthorized alterations.
1.
Please unscrew the 4 screws under the bottom enclosure when the unit is used at the first
time.
(See the procedure on page13 )
2. Ensure the voltage rating of the unit and your power supply are identical prior to use.
3. Check carefully of any damage during transportation.
4. Put the product on a safe and stable working table. Table surface should be consisted of fire and
heat resistant material due to the unit can reach very high temperature and potentially dangerous.
5. During the operation, the heater is extremely hot, and will cause serious burns if contacted
exposed skin. Use gloves and/or any heat resistant tools to pick up the PCB assembly to eliminate
the possibility of burns.
6. Do not use the product near combustible gases or flammable materials.
7. Turn the power switch OFF and allow the heater to cool before checking or replacing heater and
other parts, or prior to storing the unit.
8. Keep the appliance clean. This may be used with a damp cloth using small amount of liquid
detergent. Never submerse the unit in liquid or allow any liquid to enter the station. Never use
any solvent to clean the case.
9. This unit is designed for soldering/desoldering, hot air SMD rework and should not be used for
any other purpose without first consulting the manufacturer or its authorized agent.
10. Keep the unit out of the reach of children. Young children should be supervised to ensure that
