14
in-line filter if there is little vacuum pressure or the filters are discolored.
3.
Remove solder collector from desolder iron assembly, place finger over the hole of the collector,
depress vacuum switch. There is little suction clean or replace the collector tube.
4.
Depress vacuum witch, clean the tip tube with spring wire provided if there is no suction per the
“Procedure for Cleaning Clogged Tip” section below.
B: Hot air function option
OPERATING PRECAUTIONS
1. Make sure both heater and nozzle are cool before attaching the nozzle.
2
.
Caution High Temperature Operation
Both nozzle and hot air are extremely hot and can cause burns. Never touch the nozzle and heater
assembly or allow the hot air to blow against your skin. Initially, the iron may emit white smoke,
but this will soon dissipate.
3. Be sure to cool the unit after using. While the power switch off, the unit will automatically blow
cooling air through the pipe for a short period of time. Do not disconnect the plug during this
cooling process.
4. Do not disassemble the pump.
If the pump or other critical internal components become faulty, discontinue its use immediately. Please
return to your vendor or its authorized repairers for proper servicing.
5. Disconnect the plug while the unit is not in use.
When the power cord is connected into the power supply, the unit has a little flow of electricity;
even the Power Switch is in off position. So when you don’t use the unit for a longer period of
time, disconnect the plug.
Operation Setup
1.
Select the Nozzle that matches the size of the IC. Attach the nozzle when both heating element
and the nozzle are cool and the unit is turned off and unplugged.
2.
Loosen the screw on the nozzle and attach nozzle.
3. Press “▲” or“▼”key on the hot air function panel to choose the desired temperature or air flow.
4. Press “▲”or “▼” key to choose the desired air flow on the right side of the front panel. The
speed will change 5 degrees by pressing the keys “▲” or“▼” at a time.
5. After adjusting the air flow and temperature and wait for the temperature to stabilize for a short
period of time.
IMPORTANT
: Do not force the nozzle or pull on the edge of the nozzle with pliers. Also, do not
tighten the set-screw too tightly.
