16
EN 2.10 Shuttle Manual 1712
SW 838023
Display and keyboard
Basic settings
The automatic setting of the zero point and the mA output made by Shuttle
®
during initial
startup may be adequate.
If changes of the zero point read-out and mA output setting should be necessary, and when
Shuttle
®
is to be used as a pump controller or for level monitoring, an additional 5 settings
should be made. These settings are described in detail on the following pages.
Proceed with set-up in the order listed below:
1: Setting units of measurement
See page
17
.
2: Setting the distance from sensor to zero point and
Setting the level read-out:
See pages
18
-
19
.
3: Setting the mA output:
See page
20
.
4: Setting the the relay limits:
See page
21
.
5: Start of the learning function:
See pages
28
-
29
.
Bar graph
The bar graph can
be set to indicate
either the level
read-out or the mA
output.
Alarm
A flashing bell
indicates, that a
level is exceeded
or that
Shuttle
®
is
not certain that the
measured level is
correct.
Display
Shuttle
®
continuosly reads
out the current level with
bright and easy-to-read
figures.
Echo strength
Shuttle
®
indicates
that the ultrasonic
echo is sufficient
for a reliable level
measurement.
Relay outputs
When
Shuttle
®
measures a level
that has exceeded
a setpoint limit, the
relays are activated
and their current po-
sition are indicated
here. (Relay no. 2 is
activated.)
MJK
will always be at
your disposal.
When the settings are made, Shuttle
®
is ready to be put into service.