Xylem LOWARA TP1, Инструкция по установке и эксплуатации

Страница: 7 / 24

7 www.lowara.de
1 Notes
The installation and operating instructions in this manual must be followed when installing and operating the TP1
condensate pump. Please read them carefully. We recommend that you keep it close to the pump. Particular
attention must be paid to notes marked as follows:
If this instruction is not followed, personal safety risks could ensue.
If this instruction is not followed, the device may not function properly and could be
damaged.
Other relevant regulations must also be observed, e.g. accident prevention regulations or internal operating
and safety instructions of the system manufacturer. Failure to follow these instructions can result in the loss
of all entitlement to claim damages.
TP1 condensate pump installation and operating instructions
GB
2 Included items
(See Figure 2 Page 2)
4 Dimensions (See Figure 4 Page 2)
6 Curve
7 Installation sequence
5 Specifications
Supply voltage 100 - 240 V
Frequency 50 / 60 Hz
P1 power supply capacity 20 Watt
Current consumption 0.2 – 0.1 A
Degree of protection IP 44 / Class F
Max. delivery head 45 kPa
Max. pump capacity 450 l/h
Noise level (L
w
) 46 dB(A)
Acid resistance pH 2 or higher
Max. media temperature + 60° C
Min. ambient temperature Not freezing
Floating contact Break contact, switching capacity 250 VA
Tank volume 0.7 l (usable volume 0.5 l)
Packaging dimensions 215x215x180 mm
Packaging weight 1.6 kg
Subject to technical changes due to product modifications
WARNING
!
3 General description
The TP1 condensate pump is an automatic pump for pumping condensation water from condensing boilers, air
conditioning systems, coolers, dehumidifiers or other similar systems. The corresponding regulations on draining
to the sewage system must be observed. If necessary, a neutralising unit must be installed upstream.
Combustible liquids may not be pumped!
The condensate pump may not be run dry, as this can destroy the bearings in a very
short period. WARNING
!
8 Installation
The TP1 condensate pump must be installed in dry rooms (frostproof and where the air temperature does
not exceed 60° C) using the installation bracket provided. It is mounted to the wall below the condensate
supply outlet. Ensure that the is mounted horizontally. If floor-mounted, ensure that it is in a stable position
We recommend that you also secure it to the nearest wall.
The unit may not be installed in areas where there is a danger of explosion!
!