Xylem LOWARA e-SVE, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 46

en
– Original instructions
7
1.3 User safety
General safety rules
These safety rules apply:

Always keep the work area clean.

Pay attention to the risks presented by gas and vapors in the work area.

Avoid all electrical dangers. Pay attention to the risks of electric shock or arc flash hazards.

Always bear in mind the risk of drowning, electrical accidents, and burn injuries.
Safety equipment
Use safety equipment according to the company regulations. Use this safety equipment within
the work area:

Hard hat

Safety goggles, preferably with side shields

Protective shoes

Protective gloves

Gas mask

Hearing protection

First-aid kit

Safety devices
NOTICE:
Never operate a unit unless safety devices are installed. Also see specific information about
safety devices in other chapters of this manual.
Electrical connections
Electrical connections must be made by certified electricians in compliance with all international,
national, state, and local regulations. For more information about requirements, see sections
dealing specifically with electrical connections.
Precautions before work
Observe these safety precautions before you work with the product or are in connection with the
product:

Provide a suitable barrier around the work area, for example, a guard rail.

Make sure that all safety guards are in place and secure.

Make sure that you have a clear path of retreat.

Make sure that the product cannot roll or fall over and injure people or damage property.

Make sure that the lifting equipment is in good condition.

Use a lifting harness, a safety line, and a breathing device as required.

Allow all system and pump components to cool before you handle them.

Make sure that the product has been thoroughly cleaned.

Disconnect and lock out power before you service the pump.

Check the explosion risk before you weld or use electric hand tools.
Precautions during work
Observe these safety precautions when you work with the product or are in connection with the
product:

Never work alone.

Always wear protective clothing and hand protection.

Stay clear of suspended loads.

Always lift the product by its lifting device.

Beware of the risk of a sudden start if the product is used with an automatic level control.

Beware of the starting jerk, which can be powerful.

Rinse the components in water after you disassemble the pump.

Do not exceed the maximum working pressure of the pump.

Do not open any vent or drain valve or remove any plugs while the system is pressurized.
Make sure that the pump is isolated from the system and that pressure is relieved before you
disassemble the pump, remove plugs, or disconnect piping.