Xylem Goulds ResiBoost RB111512, Инструкция по эксплуатации

Страница: 11 / 40

4 Installation
Precautions
WARNING:
• Observe accident prevention regulations in force.
• Use suitable equipment and protection.
• Always refer to the local and/or national regulations, legislation, and codes in force
regarding the selection of the installation site, plumbing, and power connections.
4.1 Electrical requirements
• The local regulations in force overrule specified requirements listed in the following.
Electrical connection checklist
Check that the following requirements are met:
• The controller input and output cables are protected from high temperature,
vibrations, and collisions.
• It is suggested to supply power to the controller by using a dedicated power line.
• The controller must be connected to a ground fault circuit interrupter (GFCI) breaker
or receptacle.
NOTICE:
The electrical service panel must be compatible with the data of the pump and motor
that is powered by the controller. Inappropriate combinations do not guarantee the
protection of the unit and will void the warranty.
• The electrical service panel must give branch circuit overload protection to the
controller and the pump against short circuit. Refer to Technical data on page 7 for
breaker sizing.
• A time lag fuse which is inside the controller protects the system against short circuits.
4.2 Mechanical installation
NOTICE:
• Incorrect mechanical installation can cause the converter to malfunction and break.
• Read this manual and the one for the electric pump before installation.
Check that the following are adhered to:
• Proper orientation of the controller is upright and perpendicular to pump and motor.
• The controller must be full of water in order to work and read the pressure correctly.
• Do not install the controller in an area exposed to direct sunlight and/or near heat
sources. Refer to the ambient temperature range in the technical data section.
• Install the controller and pump in dry, frost-free conditions, observing the limitations of
use and guaranteeing sufficient cooling of the motor.
• Do not use the product in explosive atmospheres or in the presence of corrosive
and/or flammable dust, acid, or gas.
• Do not use the controller and the electric pump to handle hazardous or flammable
liquid.
• ResiBoost package has minimal lift capabilities. It is preferred to use on a flooded
suction. If a lift is required, be sure that suction piping is used with a minimum size to
match the suction port of the pump and with minimum fittings to reduce losses.
4 Installation
ResiBoost INSTRUCTION MANUAL 9