Xylem Goulds ResiBoost RB111512, Инструкция по эксплуатации

Страница: 34 / 40

4.
Press (5) to select rotation direction.
5.
Press (6) to confirm. Exit the menu
6.
Enter AUTOMATIC mode, press (1) , and the Mode LED (10) is illuminated and
steady.
7.7 Set the operating pressure
Refer to Figure 7: User interface on page 16 for an explanation of the buttons on the user
interface.
The controller system is set at the factory for 60 PSI. Modify the pressure value as follows:
1.
Enter MANUAL mode, press (2) , and the Start/Stop (9) and Mode LEDs (10) turn
off.
2.
Press (3) for 3 seconds and access the BASIC menu (MB) and the Mode LED (10)
flashes.
3.
Press (6) until the Pressure Setpoint
SP
parameter is displayed.
4.
Press (4) and (5) to set the new Pressure Setpoint value.
5.
Press (3) to exit the menu and the Mode LED (10) turns off.
6.
Press (1) to select automatic mode and the Mode LED (10) turns off.
7. The pump will start on based on the system conditions. The Start/Stop the LED (9) will
turn on when the pump is running.
8. Make sure that the pressure stabilizes at the required value, as seen on the pressure
gauge or on the display of the controller.
9. Make sure the pump stops when all discharge valves are closed.
NOTICE:
Make sure that the new SET POINT pressure value is within the range of the head
indicated on the data plate of the pump.
Refer to Figure 7: User interface on page 16 for additional information.
7 System Setup and Operation
32 ResiBoost INSTRUCTION MANUAL