Xycom XVME-979, Руководство пользователя

Страница: 15 / 27

XVME-979 Manual
14
Figure 2-2. Installation (CD-ROM version only)
To install the XVME-979/2 in a card cage:
1. Turn off power to the chassis.
2. Connect the jumper cable from the CPU slot to the XVME-979 slot on the rear of the
P2 backplane, as shown in Figure 2-1. This will bring the EIDE and floppy signals
over from the CPU board to the XVME-979/2. The hard drive is the “master” and
the CD-ROM drive is the “slave”.
3. Apply straightforward pressure to the handles on the front of the panel, until the
connectors are fully engaged and properly seated.
3. Once the board is properly seated, secure it to the chassis by tightening the machine
screws at the top and bottom of the XVME-979 board.
4. Turn on power to the unit.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com