Xycom XVME-400, Руководство пользователя

Страница: 25 / 83

XVME 400/401/490/491 Manual
October, 1989
N O T E
All XVME-401 signal names are in the form “XXNZ”, where “N” is
the channel number, “Z” is A or B based on the polarity of the
differential signal (as defined by RS-485), and “XX” is the name of
the signal. Also see Section 2.4.4.
All JKl and JK2 pin numbers not referenced are not connected.
2.5.2 Pl and P2 Connectors
The Pl and P2 connectors are the same physical type and have the same number of pins.
Both are 96-pin connectors consisting of three rows of 32 pins each. Like Pl, P2 is
mounted at the rear edge of the module. The pins for Pl contain the standard address,
data, and control signals necessary for the operation of VMEbus-defined NEXP modules.
(The signal definitions and pin-outs for connector Pl are found in Appendix A of this
manual.) The PI connector is designed to mechanically interface with a VMEbus defined
P 1 backplane.
,
The P2 connector (XVME-490/491 only) is a standard VMEbus P2 backplane connector.
It is designed to interface with a VMEbus defined P2 backplane.
2.5.2.1 P2 Connector Pinouts on the XVME-490 (RS-232C)
Table 2-10 shows the XVME-490 pinouts for connector P2. These signals meet the RS-232C
and VMEbus specifications.
Table 2-10. XVME-490 Rear Edge P2 Connector Pin Definitions
Pin #
9
1 0
11
1 2
1 3
1 4
1 5
1 6
Row A Signal
T X D O
RXDO
RTSO
RXCO Ch. 0
CTSO
DTRO
DCDO
TXCO
v c c GND
GND GND
N C GND
N C GND
N C G N D
N C GND
N C
GND
N C GND
TXDl N C
GND
RXDl
N C GND
RTSl N C
GND
R X C I Ch.1 GND GND
CTSl
v c c GND
DTRI N C GND
DCDl
N C G N D
TXCI N C
G N D
2-I
Row
B Signal Row C Signal