4600 Series Flat Panel Industrial PC
Chapter 2 – Installation
22
144732 (C)
Warning
Never tighten the three screws of the block plug when the cable is connected to
a power source. The screws are conductive and have full contact with the cable
wire.
6. Use the screw provided to secure and strain-relief the power cable inside the
connector. Plug the power cable into the power supply located on the side of the
unit. Install the plug retainer bracket over the plug (mandatory for Hazardous
Location installations).
7. Once the power cable and other optional interface cables are installed, the
installation is complete.
Note
When disconnecting the power cord from the unit, be sure to completely loosen
the two securing screws on the retainer bracket.
Installing Internal Hardware Options
Remove the lid to install internal hardware options.
Caution
Turn off the unit before installing internal hardware.
Warning
Installation of expansion boards may void safety and/or EMC compliance.
DRAM and Additional DRAM Dual Inline Memory Modules (DIMMs)
You can order the 4600 system CPU factory-configured for many configurations
of DRAM. The system has two 240-pin DDR2 DIMMs that support 512, 1GB and
2GB options. The maximum amount supported is 2GB. You can reconfigure the
DDR2 capacity by changing the DDR2 DIMMs on your board. For more
information, refer to the AIM4 CPU manual.
PC/AT
™
and PCI Boards
1. Check that the memory and I/O configuration of the board you want to install
does not conflict with the CPU and I/O memory maps in your AIM4 CPU board
manual.
2. Remove the lid.
3. Remove the screw attaching the plate to the frame from the desired slot.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
