4600 Series Flat Panel Industrial PC
Chapter 1 – Introduction
12
144732 (C)
Unpacking the System
When you remove the system from its shipping container, verify that you have the
parts listed below. Save the box and inner wrapping in the event you need to reship
the unit.
•
•
•
•
4600 series computer
•
•
•
•
Documentation kit, which includes:
•
Power connector
•
10-32 hex nuts (for panel mounting with the studs)
•
Cable clamp and screw (for strain-relief of power cord)
•
Documentation and Support Library CD-ROM
•
Operating System Recovery Media or operating system installation disk
(CD-ROM)
Quick Startup
This section gives you the steps to get the system up and running without
explaining the capabilities and options.
Warning
Remove power from the unit and disconnect the power cord before making any
adjustments to the inside or outside of the computer.
Warning
For Hazardous Locations installation, review “Hazardous Locations Installation”
in Chapter 2 before startup.
To prepare the system for use, perform the following steps.
1. Attach optional keyboard to the keyboard port.
2. Attach other optional equipment following the instructions in Chapter 2.
3. Attach the power cord from the power receptacle to a properly grounded 115/240
VAC, 50-60 Hz outlet. (See Chapter 3,
Creating a Power Cable
.)
4. Turn on power to the unit (via an outlet power switch, if applicable). The system
will boot-up into the operating system.
5. Install application software via the CD-ROM, or the network.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
