STEP 6: Drop down outer Chimney
1.
hold outer chimney and remove the screw driver
2.
Slightly drop outer chimney down until it perfectly sits on the hood body.
Note:
To avoid scratching the chimney, extend the inner upper chimney
slowly
and
carefully
to the chimney-
mounting bracket.
STEP 7: Install oil tunnel & baffle filters
1. PX01-I36 & PX01-I42
2. BAFFLE FILTERS:
.
1. Have a third person raise up and hood the island range hood in
position which is directly under the support brackets.
2. , connect power plug, and connect the ductwork to the range hood.
HINT: Due to the heavy weight of this range hood, use vertical
jack to lift and hold the hood in place is highly recommend it.
3. Screw hood to the support brackets on all 4 corners as show 5A
A.
DROP OIL TUNNEL: INTO THE INSIDE HOOD BODY
SLOT. REFER TO LEFT FIGURE
B.
INSTALL BAFFLE FILTERS; refer to Figure on the
left for the following three steps:
1.
Angle baffle filter toward front of hood (make
sure opposite side of the slot.)
2.
Lift a baffle filter up above horizontal level.
3.
Slide forward into slot behind the other front of
hood.
To remove the baffle, please reverse the process.
www.XtremeAirUsa.com
PAGE
8
