Xtreme XR1255, Руководство по эксплуатации

Страница: 64 / 80

Page 62
Xtreme Manufacturing, LLC
Operation XR1255
7.
With lock lever raised, insert quick attach pin
completely through the attachment and quick attach
adapter
Figure 7-26. Insert Quick Attach Pin Through Attachment and Quick
Attach Adapter.
8.
Release the quick attach lock lever and make sure
it has lowered and seated itself in groove (A) of the
quick attach pin
Figure 7-27. Make Sure Quick Attach Lock Lever Is Seated In Groove
(A) of Quick Attach Pin.
 Warning
Hydraulic attachments have a maximum
hydraulic pressure rating. Failure to make
sure the attachment is equipped with a
pressure reducing valve, or is rated to be
equal or slightly greater than 4,300 psi (296.5 bar),
which is the maximum pressure of the forklift auxiliary
hydraulic system at the quick-disconnect couplers,
could result in death or serious injury.
Make sure all hydraulic connections are tight (if
equipped).
9.
Connect the quick attach couplers (this only applies
to attachments with a quick attach hydraulic system)
Figure 7-28. Connect Quick Attach Couplers.
(A) Female Coupler. (B) Male Coupler.
Attachment Removal
NOTE:
To remove a standard carriage with forks, spread
the forks apart on the carriage shaft This provides
adequate support for the carriage to stand alone
1.
Bring the forklift to a complete stop
2.
Move the travel select lever to NEUTRAL (N)
3. Set the Parking Brake switch to ON (engaged)
4.
Extend the boom approximately 18 to 20 inches (0 46
to 0 5 meters)
5.
With attachment 10”-12” off of the ground, tilt the
attachment backward
6.
Disconnect the quick attach couplers (this only
applies to attachments with a quick attach hydraulic
system)