Xtreme XR1255, Руководство по эксплуатации

Страница: 60 / 80

Page 58
Xtreme Manufacturing, LLC
Operation XR1255
Changing Travel Direction
 Warning
Make sure the forklift comes to a complete
stop before moving the travel select lever.
A sudden change in direction of travel,
while carrying a load, can reduce stability
and/or cause the load to shift or fall, which could result
in death, serious injury, or property damage.
1.
Stop the forklift by applying the service brake
pedal If necessary, shift to a lower gear to help
slow the forklift
2.
Move the travel select lever to FORWARD (F) or
REVERSE (R)
3. Release the service brake pedal
4. Slowly press the accelerator pedal to start travel
Shut Down Procedure
1. Park the forklift on level ground, if possible
2. Stop the forklift by applying the service brake pedal
3.
Place the travel select lever in NEUTRAL (N) and set
the parking brake to ON (engaged)
4.
Lower the boom and rest carriage on ground
5. Turn the ignition key to OFF and remove the key
6. If the forklift is parked on an incline, block the wheels
Refueling
 Warning
Engine fuel is flammable and
could cause a fire or explosion.
To prevent death or serious
injury, DO NOT smoke while
refueling and keep sparks and open flames away from
the forklift.
NOTE:
The fuel tank capacity is 48 gallons (180 liters)
1.
Make sure the forklift is level to obtain an accurate
fuel level reading
2. Shut off the engine
3. Ground the fuel nozzle against the filler neck to avoid
sparks
Fuel Types
Use ASTM #2 diesel fuel with a minimum Cetane rating of
40 for better fuel economy and performance under most
operating conditions
• Use standard #2 diesel fuel for operating at
temperatures above 32°F (0°C)
• Use a blend of #1 and #2 diesel fuel (“winterized” #2
diesel) for operating at temperatures below 32°F (0°C)
• Fuels with Cetane ratings higher than 40 may be needed
in higher altitude or an extremely low temperature
climate to prevent misfiring and excessive smoke
Attachments
Attachment Disclaimer
 Warning
DO NOT exceed the manufacturer’s rated
load for any auxiliary attachment. Any
attempt to lift or carry loads in excess of
the manufacturer’s rated load could cause
forklift tip over, loss of load, or structural damage
which could result in death, serious injury, or property
damage.
Xtreme Manufacturing makes no representations or
warranties, expressed or implied, as to the design,
manufacture, or fitness for use with this forklift of any
third party attachment This forklift is not intended to
be used and should not be used with an attachment
that would alter the center of gravity or stability of this
forklift Xtreme Manufacturing assumes no liability for
any third party attachment that would alter the center
of gravity or stability