Xtreme Manufacturing XR1147, Руководство по эксплуатации и безопасности

Страница: 62 / 76

Operation Manual 62
Operation
Hydraulic attachments have a maximum
hydraulic pressure rating. Failure to make sure
the attachment is equipped with a pressure
reducing valve, or is rated to be equal or
greater than 3,500 psi, which is the maximum
pressure of the Telehandler auxiliary hydraulic
system at the quick-disconnect couplers, could result in
death or serious injury.
Warning
Figure 81. Quick Attach Lock Lever and Quick Attach Pin.
Figure 82. Quick Attach Couplers For
Hydraulic Systems.
(A) Female Coupler. (B) Male Coupler.
Figure 83. Quick Attach Lock Lever
7. Raise the quick attach lock lever.
Attachment Removal
NOTE:
To remove a standard carriage with forks, spread the
forks apart on the carriage shaft. This provides adequate sup-
port for the carriage to stand alone.
1. Bring the Telehandler to a complete stop.
2. Move the travel select lever to NEUTRAL (N).
3. Set the parking brake switch to ON (engaged).
4. Extend the boom approximately 18 to 20 inches.
5. With the attachment 10”-12” off of the ground, tilt the
attachment backward.
6. Disconnect the quick attach
couplers (this only applies
to attachments with a quick
attach hydraulic system).
8. Pull out the quick attach pin at the bottom of the quick
attach adapter.
Figure 84. Pull Quick Attach Pin from Attachment and Quick Attach
Adapter.
Figure 85. Lower Attachment to Ground in Level Position.
9. Lower the attachment to the ground in a level position.
A
B