Xtreme Manufacturing XR1147, Руководство по эксплуатации и безопасности

Страница: 59 / 76

Operation Manual 59
Operation
Standard Carriage Operation
The standard carriage uses manually adjustable forks and can
be tilted up or down by using the thumb stick on the control
handle.
Figure 73. Attachment Tilt Control Thumbstick (A).
(1) Attachment Tilt Down (2) Attachment Tilt Up
A
Figure 72. Fork Ratings
(A) Maximum Load Capacity Rating (B) 24 inch Load Center
1
2
Fork Ratings
Warning
DO NOT exceed Telehandler capacity of
11,000 lbs. The total rated capacity of the
forks being used must equal or exceed Tele-
handler capacity. Forks can break causing
loss of load and could result in death or seri-
ous injury.
All approved forks for this Telehandler are marked with a
maximum load capacity rating (A). This rating is stamped on
the left edge of the fork just below the fork pivot shaft. The
rating listed is in pounds and is based upon a 24 inches load
center (B). This rating specifies the maximum load capacity
that the individual fork can safely carry at a maximum load
center of 24 inches.
Because forks are always used in multiples, the total rating
of any combination of forks will be the sum of their rated
capacity. Other than block forks, all forks should be used in
matched pairs. Block forks should be used in matched sets.
Maximum load capacity for this Telehandler is 11,000 lbs. The
matched pair or set of forks used on this Telehandler must have
the total load rating equal or exceeding 11,000 lbs. When the
load rating of the Telehandler differs from the load capacity of
the forks, the lower value becomes the overall load capacity.
Attachment Disclaimer
Attachments
Warning
DO NOT exceed the manufacturer’s rated
load for any auxiliary attachment. Any
attempt to lift or carry loads in excess of
the manufacturer’s rated load may cause
Telehandler tip over, loss of load, or structural
damage which could result in death, serious injury, or
property damage.
Xtreme Manufacturing makes no representations or warranties,
expressed or implied, as to the design, manufacture, or fitness
for use with this Telehandler of any third party attachment. This
Telehandler is not intended to be used and should not be used
with an attachment that would alter the center of gravity or
stability of this Telehandler. Xtreme Manufacturing assumes
no liability for any third party attachment that would alter the
center of gravity or stability.
18408-001
AUX
CONTROL
AUX
CONTROL
FORK TILT
DOWN
FORK TILT
UP
JOYSTICK
ENABLE
BOOM
RETRACT
SWAY
LEFT
BOOM
EXTEND
SWAY
RIGHT
SW
AY
ENABLE
BOOM
LOWER
BOOM
RAISE