22
E-mail: [email protected]
Website: www. Xtramus.com
XTRAMUS TECHNOLOGIES
®
B. NuTAP-311 HyperTerminal Command
– counter
Command Descriptions
– counter
counter
show
The
counter show
command allows you to view all NuTAP-311
’s counter report, as
well as hardware temperature. You can also add additional commands behind the
counter show
command as listed down below:
usc
The
counter show usc [a0 | a1] [group=0 | group=1]
command allows you
to view NuTAP-311
’s USC (Universal Stream Counter) report of its
Network
Port (A0/A1)
and the USC group. For example, to view the USC in USC
group 0 for Network Port A0, please input the command
“
counter show usc
a0 group=0
”.
configure
The
counter show configure
command allows you to view
USC
’s settings.
clear
The
counter clear
command allows you to clear all counters.
refreshtime
show
The
refreshtime show
command allows you to view the refresh time for the
report.
set
The
refreshtime set
command allows you to set the refresh time (in
seconds) for the report.
setusc
The
counter setusc
command allows you to configure NuTAP-311
’s USC (Universal
Stream Counter) settings. Please refer to the sections down below for detailed
descriptions. Also, to view command lists for USC settings, you can input
“
counter
help setusc
”.
baseaddress
The
counter setusc
[a0 | a1]
[group=0 | group=1]
baseaddress
[da
| sa | vid | mpls | dip | sip | dp | sp | vlancos | vid&vlancos]
<value>
command allows you to change the specific
base address
for
NuTAP-311
’s certain
Network Port (A0/A1)
and the USC group.
Please refer to the table down below for command initial reference:
DA:
Destination Address
SA:
Source Address
VID:
VLAN ID
MPLS:
Multi-Protocol Label
Switch
DIP:
Destination IP Address
SIP:
Source IP Address
DP:
Destination Port
SP:
Source Port
VLANCOS:
VLAN Class of
Service
VID&VLANCOS:
VLAN ID and
VLAN Class of Service
For example, to set the USC in source IP address of USC group 0 for
Network Port A0 to 192.168.1.1, please input the command
“
counter
setusc a0 group=0 baseaddress sip 192.168.001.001
”.
mode
The
setusc [a0 | a1] [group=0 | group=1] mode [normal | jitter]
command allows to change the mode for NuTAP-311
’s certain
Network Port (A0/A1)
and the USC group. There are two modes
available here:
Normal:
The USC will run
under normal mode.
Jitter:
The USC will run under
jitter mode.
For example, to set the mode of USC group 0 for Network Port A0 to
normal, please input the command
“
counter setusc a0 group=0
mode normal
”.
enable/disable
The
setusc [a0 | a1] [group=0 | group=1] [enable | disable]
command allows you to enable/disable NuTAP-311
’s certain
Network
Port (A0/A1)
and the USC group. For example, to enable USC group
0 for Network Port A0, please input the command
“
counter setusc a0
group=0 enable
”.
Содержание NuTAP-311
Страница 1: ...NuTAP 311 User s Manual USM Ver 1 0 ...
