19
E-mail: [email protected]
Website: www. Xtramus.com
XTRAMUS TECHNOLOGIES
®
3.3.2. NuTAP-311 HyperTerminal Commands
After logging in NuTAP-311 via HyperTerminal, a
NuTAP-311 Command Menu
will be displayed,
showing NuTAP-311
’s HyperTerminal commands. Please see the table down below for brief descriptions
of NuTAP-311 commands:
Command Alias
Command Description
system
sys
The
system
command allows you to view NuTAP-311
’s system information,
make system configurations, and upgrade NuTAP-311
’s firmware/FPGA.
counter
cnt
The
counter
command allows you to view NuTAP-311
’s counter information and
set USC (Universal Stream Counter).
mode
mode
The
mode
command allows you to view NuTAP-311
’s current running mode or
change NuTAP-311
’s running mode (aggregate/segregate/multi-mirror).
monitor
mon
The
monitor
command allows you to view NuTAP-311
’s
Monitor Port (M0/M1)
status or configure Monitor Port
’s settings.
tapport
tap
The
tapport
command allows you to view NuTAP-311
’s
Network Port (A0/A1)
status or configure Network Port
’s settings.
ip
ip
The
ip
command allows you to view NuTAP-311
’s current IP settings or configure
these settings.
cls
cls
The
cls
command allows you to clear HyperTerminal screen.
logout
logout
The
logout
command allows you to log out. For security issues, it is
recommended that you should log out if you
’re not using the HyperTerminal
anymore.
Please see the sections down below for detailed information about each command.
Содержание NuTAP-311
Страница 1: ...NuTAP 311 User s Manual USM Ver 1 0 ...
