Xtrails VESDA-E VEP-A10-P, Руководство по эксплуатации продукта

Страница: 5 / 113

VESDA-E VEP-A10-P Product Guide
www.xtralis.com iii
Codes and Standards Information for Air Sampling Smoke Detection
We strongly recommend that this document is read in conjunction with the appropriate local codes and standards
for smoke detection and electrical connections. This document contains generic product information and some
sections may not comply with all local codes and standards. In these cases, the local codes and standards must
take precedence. The information below was correct at time of printing but may now be out of date, check with your
local codes, standards and listings for the current restrictions.
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, the user is encouraged to try to correct the interference by one
or more of the following measures; re-orientate or relocate the receiving antenna, increase the separation between
the equipment and receiver, connect the equipment to a power outlet which is on a different power circuit to the
receiver or consult the dealer or an experienced radio/television technician for help.
FDA
This Xtralis product incorporates a laser device and is classified as a Class 1 laser product that complies with FDA
regulations 21 CFR 1040.10. The laser is housed in a sealed detector chamber and contains no serviceable parts.
The laser emits light which can be hazardous to the eye. Under no circumstances should the detector chamber be
opened.
The laser chamber is identified by the labels shown below:
DANGER
DO NOT OPEN
NO SERVICEABLE
PARTS
Laser Radiation when Open
AVOID DIRECT EXPOSURE TO BEAM
NE PAS OUVRIR
DISPOSITIFS/PIECES
NON ECHANGEABLES
Rayonnement Laser en cas d’ouverture
EVITEZ TOUTE EXPOSITION DIRECTE AU FAISCEAU
CLASS 1
LASER PRODUCT
PRODUIT LASER
DE CLASSE 1
AS1603.8
The performance of this product is dependent upon the configuration of the pipe network. Any extensions or
modifications to the pipe network may cause the product to stop working correctly. All pipe network designs must be
validated using ASPIRE. ASPIRE is available from your authorized representative.
The product is not intended to be mounted in hostile environments but is able to sample from hostile environments.
AS1851.1 2005
Maintenance Standards. Wherever this document and the AS1851.1 differ, AS1851.1 should be followed in
preference to this document.
VESDA-E WiFi Availability
The WiFi connectivity is available on the VESDA-E VEU and can be disabled through software if required.
Effective from October 2020, the VEP models will not have WiFi.