Operation
XTM40
16
6.5
Using the cooler
A
➤
Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
I
➤
Close the cooler, see chapter “Connecting to a battery (vehicle or boat)” on
page 13.
I
➤
Press the “ON/OFF” button (fig.
3
1, page 10) for between one and two
seconds.
✓
The “POWER” LED lights up.
✓
The display (fig.
3
5, page 10) switches on and shows the current temperature.
I
✓
The cooler starts cooling the interior.
I
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. The cooler MUST maintain a MINIMUM of 50 mm
away from walls or similar surfaces which could restrict important air flow
requirements of the cooling system.
NOTE
Place the cooler as shown (fig.
1
, page 7). If you operate the box in a
different position it can be damaged.
NOTE
If you wish to operate the cooler from the AC power supply, set the
battery monitor to the “LOW” position.
NOTE
The temperature displayed is that of the middle of the interior.
The temperatures elsewhere can deviate from this temperature.
NOTE
During low voltage:
If switched off by the battery monitor due to low voltage, the display
goes blank, and the LED “POWER” flashes orange.
XTM40-O-AUS.book Seite 16 Montag, 7. Januar 2019 2:30 14
