1. Make sure that there are no children or other people within a working range of 15 meters (50 ft),
also pay attention to any animals in the working vicinity. Otherwise stop using the tool.
2. Before use always check that the tool is safe for operation. Check the security of the nylon cutting
head and the guard and the switch trigger/lever for easy and proper action. Check for clean and dry
handles and test the on/off function of the switch
3. Check damaged parts before further use of the tool. A guard or other part that is damaged should be
carefully checked to determine that it will operate properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other condition
that may affect its operation. A guard or other part that is damaged should be properly repaired or
replaced by our authorized service center unless indicated elsewhere in this manual.
4. Switch on the motor only when hands and feet are away from the nylon cutting head.
5. Before starting make sure that the nylon cutting head has no contact with hard objects such as
branches, stones etc. as the nylon cutting head will revolve when starting.
6. Remove any adjusting key, wrench or blade cover before turning the power tool on. An accessory
left attached to a rotating part of the power tool may result in personal injury.
Method of operation
1. Only use the tool in good light and visibility. During the winter season beware of slippery or wet areas,
ice and snow (risk of slipping). Always ensure a safe footing.
2. Take care against injury to feet and hands from the nylon cutting head.
3. Never cut above waist height.
4. Never stand on a ladder and run the tool.
5. Never climb up into trees to perform cutting operation with the tool.
6. Never work on unstable surfaces.
7. Remove sand, stones, nails etc. found within the working range. Foreign particles may damage the
nylon cutting head.
8. Should the nylon cutting head hit stones or other hard objects, immediately switch off the motor and
inspect the nylon cutting head.