XtendLan VC102SB – User’s Guide
http://www.xtendlan.com
- 10 -
5 Hardware
Description
This section describes the important parts of the Modem. It features the front indicators and
rear connectors.
Front Indicators
The following figure shows the front panel:
At a quick glance of the front panel, it is easy to tell if the CPE Modem XL-VC102SB has
power, if it has signal from its Ethernet RJ-45 port and if there is phone line signal on
RJ-11port
LED Description and Operation:
LEDs
Status
Descriptions
Ready
(
Ready LED
)
Steady Green
It will light up (ON) to show that the product is
power good, and system reset OK.
Ethernet
(
Ethernet LED
)
Steady Green
Flashing
(LINK/ACT)
Each RJ45 station port on the Ethernet is
assigned an LED light for monitoring port “Good
Linkage”. LED is normally OFF after the power
on operation, but will light up steadily to show
good linkage and flashing to show data
transmission.
VDSL
(
VDSL LED
)
Steady Green
RJ11 station port on the VDSL is assigned an
LED light for monitoring port “Good Linkage”.
LED is normally OFF after the power on
operation, but will light up steadily to show good
linkage.
