3.1.1
Speed Dome Camera Address Setting
The address code for the speed dome should be properly set before use to ensure accurate
operating order of the controller at the control centre and to control many dome cameras. The
address code is made up of ADD (8 bits) on PCB board. The 8 bits switch uses the 8421
binary coded decimal system. The largest value is established at 256. 1 means ON status
and 0 means OFF status. Each dome address code and keyboard relative screen display
mode is represented in the chart below (see the following figure and the address/digits in
following chart)
SW 2 switch (Address settings for PELCO P):
With reference to the above chart: When all code switches are under “OFF” status on speed
dome, address code is 1. When you input Numerical key No.1 on control keyboard, then
press CAM key for confirmation showing that set keyboard address as No.1 control address.,
At this time, keyboard can control speed dome camera(its control address is 0001). Other
address is to be set as above.
SW 2 switch (Address settings for PELCO D):
Содержание SDOME4802201
Страница 12: ......
