28
Record packing duration= Alarm du duration set in linkage recording
parameters.
[Set detective area]: Left click and drive the mouse to set the surveillance
areas (4 areas at most).
[All]: Set the whole video as motion detection area.
[Clear]: Clear all motion detection area.
After set all the parameters, click [save] to make the parameters valid.
4.
Network Failure
Below pic
ture is the “network failure alarm settings” page of DVS:
In this page, users can set features like network failure detection on/off,
linkage alarm output, linkage output duration, E-mail sending after alarm is
triggered, linkage device snapping/snapping, etc.
[Detection On/Off]: Open or close network failure alarm detection.
[Linkage alarm output]: When alarm is triggered, the built-in relays will be
driven to output alarm.
[Alarm Output Duration]: Set the duration of the linkage alarm output after
being triggered (in seconds), the range of the duration is 0~86400s.0 means that
there is no limit for alarm output.
[E-mail Sending]: Send video loss detection alarm information to users via
E-mail, details about E-mail setting please refer to [Network Settings].
[Linkage Snapping]: Drive device snapping after alarm has been triggered,
and save pictures to device HDD. For snapping parameters, if the number of
pictures snapped at one time is set as 5, and the snapping interval is 1 second,
that means when there is an alarm, 5 pictures will be snapped and the interval
between each picture is 1 second. The pictures snapped can be saved via
E-mail sending or FTP uploading.
[Linkage Recording]: Drive device recording after alarm has been triggered,
and save record files to device HDD. The record files can be saved via FTP
uploading.
Note:
