XtendLan IP SENSOR ESZ-162, Руководство пользователя

Страница: 12 / 20

- 12 -
1. Power (Voltage) monitoring
The first column on the right side of the webpage is voltage monitoring (
（
Maximum current for P1 is 4V
，
for P2 is 5.8V
，
for P3 is 15.5V
）
, displaying the real time value of 3 DC voltages. User can set the value in
setup sensor sub-webpage. User can set the upper limit and lower limit of the voltage or turn on/ off the alarm.
2. Temperature monitoring
in the temperature monitoring column on the right side of the webpage, it displays 3 sets of real time
temperature value( 2 sets of external temperature monitoring, 1 set of circuit board temperature monitoring).
User can set the upper limit when make an alarm and the lower limit when alarm stop, or turn on / off the alarm.
3. Fan monitoring
in the fan monitoring column on the right side of the webpage, it displays 3 sets of real time rotate speed. User
can set the lower limit of rotate speed when make an alarm or turn on/ off the alarm.
4. external digital voltage level monitoring
It is used to monitor the voltage in 16 route digital input port. is high level or low level. DI 9
— 16 can be set to
DRY or WET contact.
IP settings of ESZ-162
The IP settings of ESZ-162 can be modified through XtendLan Network Assistant or modify it in the webpage.
Click the
setup option on the left of the webpage; you can enter the IP setting webpage as the figure below
shows:
Please fill in the new IP address, subnet mask, default gateway etc.
Notice: when finish setting, you need to click submit button to confirm your settings.
1. IP address
Fill the new IP address you plan to use for ESZ-162 in the IP Address column. The new IP address of ESZ-162
must be in the same subnet with the PC, so the PC can control ESZ-162. for example, if the IP address
of your PC is 192.168.10.110, subnet mask is 255.255.255.0, the IP address of ESZ-162 should be set to
192.168.10.XXX (XXX is from 1-255, and the IP address has not been occupied by other PC or equipments
in the same subnet) .
2. Default Gateway
if you local network is connect to the internet through router address mapping or gateway and you want to
control the ESZ-162 through internet, you should fill the correct gateway address in the Default Gateway
column.