XTA 4 Series, Руководство оператора, Страница: 36 / 58

Page 36 4 Series 4 Series 4 Series 4 Series Operator’s Manual
Unit Cloning
The unit cloning feature allows the entire “personality” of the unit to be copied onto a PC card for backup purposes, or so
another unit can be instantly reconfigured to operate identically. This will include all user memories, and all user selectable
menu options. Note that OEM presets will not be copied – use the procedure below to copy preset files.
Select
Unit Cloning
Unit Cloning Unit Cloning
Unit Cloning
from the
SYSTEM Sub
SYSTEM Sub SYSTEM Sub
SYSTEM Sub-
- -
-Menu
Menu Menu
Menu
and then choose to
Store
Store Store
Store
or
Recall
Recall Recall
Recall
the cloning
information as appropriate. The unit will reboot after the recall procedure.
Copying Unit Software and Preset Files
It is possible to copy the operating software or preset file (or both) onto a PCMCIA card to allow this data to be used in
another unit. This procedure is not part of the standard menu system, and must be initiated on power-on with a special
key sequence.
Copying Data from Source Unit
Switch the unit on with the
MENU MENU MENU MENU
key held in momentarily. After a few seconds, the unit will ask for a security code.
Use the
EDIT EDIT EDIT EDIT
keys in the same manner as for entering lock codes (see page 33 for details) and enter the following code:
1AB4 to copy the software only;
3AB4 to copy the presets only;
2BB2 to copy the software and the presets.
Be sure to set the Write Protect switch on the card ON before removal, as data corruption can occur as the card is pulled
out of the slot.
Loading Data into Destination Unit
If the unit is already running, copy the software /presets as explained previously on page 33.
Cold Start Reboot Procedure
Please only undertake this procedure if you are confident with internal workings of electronic
devices – dangerous voltages exist internally and XTA cannot be held responsible for any damage
caused to the unit, or user. If you are in any doubt about what to do, please call us and we can talk you
through the process, or return the unit to your local distributor.
This procedure explains how to reboot a unit and load new software
when there has been a problem during a remote download (for
instance the PC has crashed or the unit was switched off duing the
update).
Take the top cover off the destination unit, taking care NOT to touch
the power supply or mains inlet. Move the link maked PC REG to the
location marked SWAP.
Insert the PC card containing the software and switch the unit on.
It should boot up and display
Erasing Flash Erasing Flash Erasing Flash Erasing Flash
then begin loading
the new software. The the process is complete it will prompt for the
link to be put back to PC REG. Remove the card and switch the unit
off and on again. If successful, it will boot up normally and display
New New New New Software Software Software Software
.
Make sure the link is put back on PC REG or the card slot will not
function. Replace the cover.