Xstream X-HW13008GEN, Руководство по эксплуатации

Страница: 22 / 40

22
UNlOADER
THERMAl RElIEF VAlVE
PRE-START INSPECTION PROCEDURES
Standard Models: The unloader has been preset at the factory.
Steam Option Models: The unloader has an adjustment knob which has a
minimum/maximum setting. Move the unloader clockwise to the maximum
setting for Cold/Hot water operation. Move counterclockwise to minimum
setting for Steam operation.
To ensure the water temperature does not exceed acceptable levels,
never allow the pressure washer to operate in the bypass mode (with the
unit running and the trigger closed) for more than three minutes.
A thermal relief valve has been added to this unit to protect the pump.
This valve will open and release water if the water temperature in the
pump has exceeded 140° F. This will allow fresh, cool water to enter the
system, therefore preventing premature failure of pump packings.
Before starting the unit, perform the following procedures:
1. Inspect the electrical cords for cuts. If a cut is found, DO NOT TOUCH
OR USE CORD! Replace cord before starting unit.
2. Check the oil level in the pump.
3. Inspect the water inlet strainer. Clean or replace if necessary. See
“Water Supply”, #21.
4. Check all hose connections to ensure they are securely tightened.
5. Inspect for system water leaks, oil leaks and fuel leaks. If a fuel leak is
found, DO NOT START UNIT! See “Risk of Explosion or Fire”, pg. 8.
Be sure that all damaged parts are replaced and that the mechanical
problems are corrected prior to operation of the unit. If you require
service, contact Customer Service.
6. Inspect high pressure hoses for kinking, cuts and leaks. If a cut or leak
is found, DO NOT USE HOSE! Replace hose before starting unit.
See “Risk of Injection or Severe Cutting Injury”, pg. 9. Be sure that all
damaged parts are replaced and that the mechanical problems are
corrected prior to operation of the unit. If you require service, contact
Customer Service.
installation & preparation