Xray T4'21, Инструкция по эксплуатации

Страница: 31 / 48

31
SHOCK & SPRINGS
CHOICES
VIDEO TECH TIP
▶
RELEASE 2-3 turns TIGHTEN FULLY
0%
50%
75%
REBOUND ADJUSTMENT
REBOUND CHECK
➊ ➋ ➌
100%
25%
AFTER THE SHOCK IS ASSEMBLED YOU HAVE TO SET THE SHOCK REBOUND:
➊
Release the shock cap by 2-3 turns.
➋
Push the shock shaft fully up. For the first time the extra oil will release through
the hole in the alu cap-nut.
➌
Tighten the shock cup. When tightening the shock cap, extra oil will again release
through the hole in the alu cap - nut. When tightening, the shock shaft will push
out from the shock body.
SHOCK LENGTH ADJUSTMENT:
It is VERY IMPORTANT that all shocks are equal length.
Fully extend the shock absorber and measure the end-to-end length; we
recommend using digital calipers to give an accurate measurement. If a shock
absorber is shorter or longer than others, adjust the shock length by tightening
or loosening the ball joint on the shock rod.
REBOUND CHECK:
It is very important to push the shock shaft into the shock body slowly otherwise air can come into the shock body
which would create bubles.
100% rebound - do not do step 2 and 3
75% rebound - repeat steps 1 to 3 until the shock shaft will push out 75% of its length
50% rebound - repeat steps 1 to 3 until the shock shaft will push out 50% of its length
25% rebound - repeat steps 1 to 3 until the shock shaft will push out 25% of its length
0% rebound - repeat steps 1 to 3 until the shock shaft will push out 0% of its length
If the shock shaft does not rebound enough, you will have to refill the shock with shock oil, and then repeat the
bleeding and rebound adjustment procedure.
When installing the shock cap assembly on the
shock body, some oil will leak out... this is normal.
Tighten the cap and clean off any excess oil.
After the shock is assembled, the shock rod will
push itself out of the shock body fairly quickly.
Follow the next procedure to adjust the rebound.
➍
➊
➋
➌
6. SHOCK ABSORBERS
ASSEMBLY VIEW
#308031-O
ALU XRAY SHOCK SPRING RETAINING COLLAR - ORANGE (4)
#308031-K
ALU XRAY SHOCK SPRING RETAINING COLLAR - BLACK (4)
Install the balls with Professional Multi
Tool (HUDY #183011)