Xray T1 EVO2, Инструкция по эксплуатации

Страница: 18 / 23

17
308300
309452
301330
303091
309334
309393
309335
309333
Mount the #303091 rear shock tower onto the rear bulkhead with
#309333 (SH M3x6) screws.
1 1.. Push two #309335 (SH M3x10) screws through the indicated
holes in the rear shock tower.
2 2..
Thread two #309393 (M3) nuts onto the screws and tighten onto
rear shock tower.
3 3.. Thread the top pivot balls of the assembled rear shocks onto the
ends of the screws.
4 4..
Thread the lower pivot ball of the assembled rear shocks to the
exposed screws on the lower suspension arms.
Refer to the Set-Up Book
to gain a better
understand of different shock
mounting locations.
30 1330 REAR BODY MOUNT SET
30 3091 ULTRA-TUNE SHOCK TOWER REAR - 2.5 MM GRAPHITE
30 9333 HEX SCREW SH M3x6 (10)
30 9334 HEX SCREW SH M3x8 (10)
30 9335 HEX SCREW SH M3x10 (10)
30 9393 NUT M3 (10)
30 9452 PIN 2x10 (10)
30 8300 XRAY SHOCK ABSORBERS
1 1..
Glue the rubber washers onto the top of the plastic body post
stops.
2 2..
Mount the body posts to the front of the rear shock tower as
shown; the bottom plastic pin fits into the bottom hole on the
shock tower. Use a #309334 (SH M3x8) screw to fasten each
body post to the rear shock tower.
3 3..
Insert a #309452 (P 2x10) pin into one of the holes of the
rear body post. Insert the other #309452 (P 2x10) pin into the
same hole in the other body post.
4 4.. Slide the body post stop down over the post, and snap it over
the pin.
➊
➊
➋
➋
8. REAR FINAL ASSEMBLY
BAG
08
309333
SH M3x6
309334
SH M3x8
309335
SH M3x10
309452
P 2x10
BASIC LOCATION
➌
➌
➍
➍