Rev.: 20191108
Platform: DBALL2
Firmware: BMW03
© 2019 Directed. All rights reserved.
Remote
Starter
10
Programming button
LED
14
12
2
5: Orange/Green: FT CAN High
6: Orange/Brown: FT CAN Low
1: Black/White:
(-) KIBMW5 Output
7: Brown: NO Relay1
10: Orange/Red: NC Relay2
8: Yellow: COM Relay1
11: Yellow/Red: COM Relay2
9: Orange/Yellow: NC Relay1
(-) Parking/Neutral Input
RF Loop connector
(+) 12 V
(-) Ground
(+) Ignition Intput
Twisted pair in driver kick panel
CAN High:
Black
CAN Low:
Yellow
(-) Ground
7: Gray/Black: (+) Ignition Status Output
Purple/White
Blue/Red
Blue/Red
Brown/Gray
Brown/Gray
Brown/Black
BCM
CUT
CUT
Located at
brake pedal
Brake switch
1
2
3
4
Wire Side View
3: Green/White: (-) KIBMW5 Output
4: Red/Black: (-) KIBMW5 Output
10: Yellow/Black: (+) KIBMW5 Output
P#: XKD2D65
D2D
D2D
5: Violet/White: (AC) Tach Output
(AC) Tach Input
6: Gray: (+) KIBMW5 Output
INSTALLATION
-
TYPE
3
(
Automatic Transmission
)
Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.
With the exception of the OBII Diagnotistic plug, all connectors are displayed from the wire side.
C
onnections
between
DBALL and KIBMW5
module
are ready-made
KIBMW5 MODULE
(+) 12v
(-) Ground
Connect the KIBMW5 Cable to the Ignition Switch
after programming the DB-ALL module
12
turns
Make 12 loops and place them around
the front of the plastic body
of the vehicle’s coded key as shown.
Page 9
DBALL/
DBALL2
You must set “wait to start” feature menu at 10 seconds on your remote starter unit.
