
https://www.XPOtool.com
Item 62820, 62821
Page 4
The Tool Experts
01 2022-1
•
This device is not intended for use by persons (including children) with reduced physical, sen-
sory, or mental capabilities or lack of experience and knowledge, unless they are supervised or
instructed by a person responsible for their safety.
•
Carefully read these instructions and the safety instructions. Keep the instructions so that you
can refer to them at any time.
•
Always switch off the power supply at the power source before inserting or removing the mains
plug. Always pull devices out of the socket by the mains plug, do
not
pull the cable for this
purpose.
•
Switch off devices and disconnect them from the power source when not using them or before
carrying out cleaning operations.
•
Only use your device with an extension cable if this cable has been tested by a qualified tech-
nician.
•
Always use your device on a power outlet with the voltage specified on the device (AC only).
•
Never
leave the device unattended while in use.
•
Only use devices for their intended purpose.
•
Do
not
place a device on or near a gas flame, an electrical element, a heated stove. Do not
place it on top of another device.
•
Never
let the power cable hang over the edge of a table or come into contact with a hot surface.
•
Never use an electrical device if the power cable or device is damaged in any way. If you suspect
damage, have the device repaired by a professional.
•
Only use the pump as described in the instructions. Only use accessories recommended by the
manufacturer.
Durability
•
Your submersible pump is intended for the circulation of water with a maximum temperature of
35
℃
.
•
This pump must not be used for other liquids, especially not for fuels, cleaning liquids or other
chemical products!
Assembly
The pump can be installed as follows:
•
in a fixed position with fixed piping or
•
in a fixed position with flexible hose pipe.
Note:
You should never install the pump by suspending it unsupported from the discharge line or the
mains cable.
•
The submersible pump must be suspended from the handle provided or placed on the bottom
of the shaft.
•
To ensure the proper functioning of the pump, the bottom of the shaft must be kept free of mud
and dirt of all kinds.
•
If the water level drops too far, the mud in the sump dries out quickly and prevents the pump
from starting. Therefore, it is necessary to check the pump regularly (by performing commis-
sioning tests).
•
The float is set so that the pump can be started immediately.
Note!
The pump should have a minimum size of 40×40×50
cm so that the float can move freely.
Power supply
The pump is equipped with a safety plug in accordance with regulations. The pump is designed for
connection to a 230
V~50
Hz safety socket. Make sure that the device is in perfect condition. Insert the
plug into the socket and the pump is ready for operation.