https://www.XPOtool.com
Item 62296
Page 8
The Tool Experts
05 2022-1
Notes:
•
When using the demolition hammer for the very first time, it should only be used at lower speeds
for the first 24
hours to extend its service life.
•
To achieve the best work results, it should be sufficient to operate the demolition hammer at
medium speed.
Stopping
•
Let go of the acceleration switch and let the machine run in idle state for about 1–2
min.
•
Then halt the motor by pressing the red stop switch (see Figure 6).
Maintenance
Air filter
Regularly check the air filter. Accumulations of dust and dirt may block it and as a result reduce the
capacities of the motor and damage the cylinder. In case of the filter being dirty, remove it and carefully
clean it with mild detergent and lukewarm water. Make sure that the air filter has dried completely before
it is reinserted. If the air filter should show signs of wear or damage, repair or replace it with a new one.
If working in especially dusty environments, the maintenance cycle must be adjusted accordingly.
Oil filter
A clogged oil filter reduces the demolition hammer's working speed as well as its power of impact and
does thereby not only affect its performance, but also increases the risk of the machine being damaged
and its operator being injured.
Oil filter removal:
•
Open the fuel tank cap (see Fig.
7) with a metal hook (see Fig.
8, 9) and carefully remove the
oil filter from the tank.
•
Removing the oil filter at the same time cleans the oil tank.
Carburettor
It is common for both, the oil tank as well as the carburettor to keep a certain amount of fuel residue.
Over the time this residue might cause the fuel line to get clogged, which will prevent the motor from
starting. It is therefore advised to completely remove the fuel from the demolition hammer, if it is not
used at least twice a week. To completely remove the fuel from the system of the machine, utilise the
primer.
