Xplore 304, Руководство пользователя

Страница: 160 / 206

10-6
CARE OF YOUR CARAVAN
(ii) Slacken off the wheel bolts on the wheel
to be changed.
(iii) Ensure all corner steadies are in the up
position before commencing jacking of
the caravan.
(iv) With a suitable jack, jack up the caravan
under either the axle tube, the axle
mounting plate or designated jacking
point.
Please note: Do Not Use The Chassis As A
Jacking Point. If there is lack of ground
clearance because of a flat tyre, gently move
the caravan onto some ramping boards.
(v)
Support the weight of the caravan with
the jack and for added safety lower the
front and rear corner steadies on the
side of the flat tyre. Then remove the
ramping boards.
(vi) Remove the wheel bolts and remove the
wheel.
(vii) Before fitting the wheel, examine it for
distortion or other damage. Ensure that
all mating surfaces are clean and dry,
including bolt/nut seats.
Please note: Always Use the Correct Bolts to
Secure the Wheel - Check with the dealer if
unsure.
Please note: A corner steady brace is not to
be used for the next step.
(viii) Insert the wheels bolts.
(ix) After the bolts have been screwed in as
far as possible by hand, each bolt
should be tightened gradually in
sequence. Do not over tighten at this
point as the final tightening should be
done with a calibrated torque wrench.
The wheels of the caravan will not rotate
during tightening as they are held rigid
by the wheel hub brake unit.
(x) Raise the corner steadies.
(xi) Lower the caravan to the ground.
(xii) The wheel bolts should be tightened
ensuring that the torque is applied
evenly around the wheel. Using a
suitable torque wrench, sequentially
tighten the steel bolts to a torque of
102Nm for steel wheels and 130Nm for
alloy wheels following the sequence
stated above.
IMPORTANT
• The torque settings should be re-
checked after 50 km (30 miles).
• Do not use acidic cleaning products
on the wheel bolts.
• Do not loosen the wheel bolts to
carry out this operation whilst the
road wheel is supporting the weight
of the caravan.
• Wheel bolts should NEVER be
lubricated.
• NB: If you upgrade from steel to alloy
wheels you must ensure you use the
correct bolts for the new wheel.
JACKING
Under no circumstances should the corner
steadies be used to jack up the caravan.
When it is necessary to jack up, use a bottle,
screw, trolley or scissor type jack, one with an
axle shaped head is recommended.
Place the jack plate under the axle tube as
near as possible to the main longitudinal
member. The maximum mass which the
jockey wheel and its clamping mechanism
are capable of withstanding is as per the
technical data sheet provided with the
vehicle.
LUBRICATION
• Lubricate the Jockey Wheel spline
• Lightly oil the wheel axle and screw
thread.
• Lubricate the Brake Linkage
• Lightly oil all moving parts.
• Lubricate the Corner Steadies
• Lightly oil the screw and pivot pins.