Series EJ, ET, EY, FJ & FR
102002-177 Rev M2
2
\1020\02177M2.doc 17 Jun 2019
This symbol, wherever it appears on the supply, alerts you to the
presence of uninsulated dangerous voltages - voltages that may
be sufficient to constitute a risk of electrical shock
.
This symbol, wherever it appears on the supply, alerts you to
important operating and maintenance instructions in the
accompanying literature. Read the manual.
SAFETY
TERMS IN THIS MANUAL
CAUTION
statements identify conditions or practices that could result
in damage to the equipment or other property.
WARNING!
statements identify conditions or practices that could
result in injury or loss of life.
WARNING!
If this equipment is used in a manner not specified herein, the protection
provided by the equipment may be impaired.
To avoid the risk of shock or fire do not attempt to service the supply beyond
that described in these instructions.
To avoid the risk of shock and personal injury, do not remove the product
covers while the unit is operating or connected to the AC mains. Wait at least 3
minutes after disconnecting the AC mains power before removing any covers or
panels. Wait at least 15 seconds before disconnecting the HV cable.
Upon loss of protective ground connection(s), all accessible conductive parts can
render an electric shock.
Use the NRTL listed power cord provided by the manufacturer, or use only a
NRTL listed power cord rated greater than the input current rating of the unit.
Use only a cord in good condition.
To avoid fire hazard, use only fuses of the correct type, voltage rating, and
current rating as specified.
To avoid explosion, do not operate this product in an explosive atmosphere.
If liquid is spilled on the supply, shut it off immediately and disconnect it from
the AC mains.
Always maintain adequate supply ventilation. All ventilation openings must
remain free from obstruction.