2. Turn ON/OFF:
*The power of the flash ligth can be opened or close by holding this button for 2 seconds. It is
suggested that the battery shall be taken out after the power of the flash ligth is closed thro-
ught this button.
*After opening the power switch of the flash,the flash will fetch the setting state saved in the
close down last time,the charging indicator is green,which indicates the flash is avallable.
*If the charging is not completed within 20 seconds, shortage of power supply can not to
flash. Then you need to replace with new batteries.
*You may press the testing button <PILOT> to test whether the flash works normally.After
use, hold the power switch for 2S to power off.
3. M Mode
In M mode, you can set the flash output level as you like. you can adjust the flash output level.
The adjustment range of the flash output level is 1/128-1/1. There are 8 levels of output and
each level has 6 fine tuning stalls. The <left><right> is used to fine tune the output power.
The output level is indicated by the output power indicator. For shooting, what you need is
to set the flash output level, adjust the camera and press the shutter.The flash will flash with
the synchronic signal of the camera.
-10-
