Twin WAN Series – User Guide | v1
To use the XiNCOM VPN Gateway with a software VPN client that uses a dynamic IP
address, it is required that the Remote Security Gateway and the Local Identity Type are
set to a Distinguished Name. This permits the two endpoints to authenticate between each
other.
Figure 18-b. Traffic Selector Console.
The
Traffic Selector
menu allows you to set which computers will have access to the
VPN tunnel. If a computer is not within the Local or the Remote Security Networks, any
attempt to request traffic from the other side of the VPN tunnel will be unsuccessful. If
you want the traffic between the VPN tunnels to be proxy or filtered, it is recommended
that you set the Local type to IP address and specify the Proxy or the Firewall IP address.
When connecting two endpoints together it is recommended that you make the whole
subnets available to access the VPN tunnel. This is accomplished by setting the Remote
and the Local Type to Subnet. When you specify the IP address, it must end in with a
"zero" on the end as shown in the example above.
Traffic Selector - Settings
Service
Protocol Type: You can choose either TCP/UDP/ICMP/GRE protocol as your connection
protocol. By default the protocol type is
Any
.
Local Security Network
These entries identify the private network on the VPN gateway and the hosts of which
can use the LAN-to-LAN connection. You can choose a single IP address, the subnet, or
a selected IP range to make VPN LAN-to-LAN connection.
Remote Security Network
These entries identify the private network on the remote peer VPN router whose hosts
can use the LAN-to-LAN connection. You can choose a single IP address, the subnet, or
a selected IP range to make VPN connection.
Copyright © 2005 WINS International, LLC dba XiNCOM | All rights reserved.
64
