12
Virtex-6 FPGA Connectivity Kit Getting Started
UG664 (v1.4) July 6, 2011
Getting Started with the Connectivity Targeted Reference Design Demo
•
Software driver for 32-bit Windows and 32-bit Linux platforms:
•
Configures the hardware design parameters
•
Generates and consumes traffic
•
Provides a Graphical User Interface (GUI) to report status and performance
statistics
Hardware Demonstration Setup Instructions
This section describes how to set up the hardware demonstration for the Virtex-6 FPGA
Connectivity TRD. This demonstration outlines a bridging function between PCIe and
XAUI protocols. It also provides accesses to an onboard DDR3 memory.
1.
Equipment Checklist: The following equipment is required to run the hardware
demonstration:
•
Virtex-6 FPGA Connectivity Kit
•
PC system with a x8 PCIe slot on the motherboard, CD ROM drive, and a USB
port
•
Monitor, keyboard, and mouse
2.
Inadequate Equipment: Run the alternate demonstration.
If there is no access to any of the equipment in
Virtex-6 FPGA IBERT Reference Design, page 64
to alternately bring up the ML605
board included in the Virtex-6 FPGA Connectivity Kit. Otherwise, continue with the
PCIe to XAUI protocol demonstration in
.
3.
Completion of Hardware Setup Guide Checkpoint:
If the instructions in the Virtex-6 FPGA Connectivity Kit Hardware Setup Guide have
already been completed to bring up the Virtex-6 FPGA Connectivity Kit, proceed to
Evaluating the Virtex-6 FPGA Connectivity TRD, page 33
; otherwise, continue to
4.
Hardware Setup I:
Board setup and configuration.
The ML605 board is shipped with the FMC Connectivity daughter card attached to the
FMC_HPC connector (see
). To run the Connectivity TRD demonstration, you
need to externally loop back the XAUI data through a CX4 loopback connector
provided in the connectivity kit.
a.
Verify the switch settings are correct:
-
Switch S1: 1 = OFF, 2 = OFF, 3 = OFF, 4 = ON
-
Switch S2: 1 = ON, 2 = OFF, 3 = OFF, 4 = ON, 5 = ON, 6 = OFF
b. Verify that Jumper J42 has pins 3-4 shorted.
c.
Plug in the CX4 loopback connector:
-
Remove the plastic pin protector.
-
Plug in the CX4 loopback connector on the FMC Connectivity daughter card’s
J2 connector (see
Содержание Virtex-6 FPGA
Страница 1: ...Virtex 6 FPGA Connectivity Kit Getting Started Guide UG664 v1 4 July 6 2011 XPN 0402826 03...
Страница 4: ...Virtex 6 FPGA Connectivity Kit Getting Started www xilinx com UG664 v1 4 July 6 2011...
Страница 6: ...6 www xilinx com Virtex 6 FPGA Connectivity Kit Getting Started UG664 v1 4 July 6 2011...
