
Chapter 5
LEDs
The LEDs on the T1 card are listed in the following table.
Table 9: T1 Card LEDs
Ref Des
LED Name
Description
D8
VCC_ATX_12V_IN
Green LED. On when 12V ATX power source is present. Off if
12V power source is not present.
D10
SC_STATUS_LED
Green LED. On when SEQ3 PG is high. Off if power sequence
is not initialized properly. Blinks at an interval of every four
seconds before thermal shutdown.
D12
RF_CONFIG_DONE
Orange LED. On when the Zynq Ult RFSoC PL
configuration is completed.
D13
RF_LED
Green LED. Connected to SoC for workload usage. LED is
user defined.
D14
RF_PS_TEST_LED
Green LED. Connected to SoC for workload usage. LED is
user defined.
D15
MP_CONFIG_DONE
Orange LED. On when the Zynq Ult MPSoC PL
configuration is completed.
D16
MP_LED
Green LED. Connected to SoC for workload usage. LED is
user defined.
D17
MP_PS_TEST_LED
Green LED. Connected to SOC for workload usage. LED is
user defined.
Chapter 5: LEDs
UG1495 (v1.0) December 17, 2021
T1 Telco Accelerator Card User Guide
38