XIEGU G90, Шпаргалка

Страница: 3 / 13

XIEGU G90 CHEAT SHEET
3
FUNC Button Initiate a Second
Function for other
Buttons or Controls
.
System Menu

A short press turns on the amber LED below the button and initiates the second function by
some other button or control. These are detailed below.

A long press
of this button will bring up the ‘System Menu’ to allow configuring various aspects
of the G90’s operation. In each case use the ‘VM’ button to step through the ten options. When
making a change to one of the ten
, press the ‘CMP’ button to save the settings and exit.. Here is
a brief overview of the options:
1.
Hand Mic Up / Down button .. this allows setting the f
unction of the hand held mic’s up /
down button’s. Rotate the tuning control to select from: Freq CH +/-, Band +/-, or /-.
2. Hand Mic F1
.. this allows assigning a function to the hand held mic’s ‘F1’ button. Rotate the
tuning control to select from PRE/ATT, SPLT (Split operation), NB (noise blanker), COMP
(speech compressor), or AGC
3. Hand Mic F2
.. this allows assigning a function to the hand held mic’s ‘F2’ button. Rotate the
tuning control to select from the same choices as shown above for the ‘F1’ button.
4. LCD BL .. rotate the tuning control to specify the desired brightness of the display from 10%
to 100%.
5. AUX IN Volume
.. use the tuning control to specify the desired ACC port’s Aux In volume
from 0 to 15 (bigger is louder)
6. AUX OUT Volume use the
tuning control to specify the desired ACC port’s Aux Out volume
from 0 to 15 (bigger is louder)
7. RCLK (reference clock) Tune . Rotate the Tuning Control to select the desired negative or
positive value.
8. Band Stacking Mode
. Select ‘Ham Band’ or ‘Full Band’.
9. G90 on / off beeping sound
. Select ‘Enable’ or ‘Disable’.
10. Version ..
displays the G90’s current versions of the ‘APP’ and ‘BASE software
Note that the top mounted Band Up and Band Down buttons may also be used to step through
these 10 choices.
Factory Reset G90 To complete a factory reset of the G90 press and hold the "FUNC" key and power on the G90. Then press
the "PRE" key to confirm the reset or press the "VM" key to cancel the reset.
‘MW .MC’ Button
Store
VFO’s Frequency
To Memory
Clear a Memory
location

There are memories from 00 to 63

Press ‘MW.MC’

Adjust the Tuning control to select the desired memory channel.

Press ‘MW.MC’ button again to save the value.

You must use memory 00 first .. there after use any of the memories

Press ‘FUNC’ then ‘MW.MC’ to clear a memory

Note that the memory
’s are not directly tunable.