BASIC SETUP:
The list of measures and commands available in the current software release are
described in the protocol section.
If the adaptor is going to be used in a flight vehicle and on this application is necessary to
have the information of fuel flow and remaining tank capacity, due that several fadec
models don’t support these measures, the adapter itself can calculate these values from
the data retrieved from the fadec, plus a couple of parameters to be programmed on the
adapter. This programming is only necessary if you plan to use the fuel flow and tank
capacity information.
The programming procedure is:
Connect the data terminal to the fadec port on the telemetry adapter trough a “Y” servo
lead. Connect a battery (4 to 8V) on the other port of the lead to power both devices.
Connect the battery last, after both devices are already connected.
The RED led on the adapter will lit, and the data terminal will display
Tank capacity:
using +/- buttons set the tank capacity on your model in
milliliters. (1Oz=29,6ml)