Page 40
Diagnosis messages:
1.
UserOff:
The engine has been shut down because it has received the shut down command
from the transmitter.
2.
FailSafe:
The engine has been shut down because of loss of the control signal from the
transmitter. After 0,5s of detecting a loss or invalid RC signal, the ECU sets engine power to idle,
and if after another 1,5seconds a valid signal is still not received the engine is shut down.
3.
LowRPM:
The engine has been shut down because the RPM has dropped below a mini-
mum. Cause could be lack of fuel, air bubbles, problem with the batteries, or defective RPM sensor.
4.
RCPwFail:
Lack of power from the radio receiver.
Telemetry:
Xicoy Electronica offers several additional modules that allow transmitting the engine data in real
time to an external receiver.
Using the Blue1 module is possible to connect to Android and Apple smartphones.
Using the TeleSpek module is possible to connect to Spektrum radios.
Using the Flight Computer device is possible to connect to the following RC equipment: Spektrum,
Jeti, Futaba, Multiplex, HoTT, FrSky, PB Core and JR DMSS.
Using the TelemetryX module is possible to connect to the following RC equipment: Jeti, Futaba,
Multiplex, HoTT, FrSky, PB Core and JR DMSS.
If you purchase the TelemetryX module, it will be necessary to configure it to your radio brand.
Follow the instructions of the module, except if you purchased the Compact version. In this case,
to access to the telemetry module menus, you should disconnect the cable to the engine, and
power-up the system while holding pressed the first button on the left on the display module.
