Xerox WorkCentre C2424/DX, Руководство по обслуживанию

Страница: 238 / 432

4-80 WorkCentre C2424 Service Manual
7.
Using the system control panel, disable DHCP/BOOTP and AutoIP so that the
system can be configured manually.
8.
Select an IP address for the system that matches the computer, except for the last
field, which must be unique.
9.
Edit the system’s gateway and subnet mask to match the computer.
10.
At the MS-DOS command prompt, type “ping” followed by a space and the
system’s IP address. Then press
Enter
. If the number of packets sent and
received match, the PING was successful and the Ethernet port is functional. If
the request times out and fails to reply, either the cable or the port is defective.
Ethernet Port Verification for Default Assigned IP Address
169.254.xxx.xxx
An alternate method is required to test the Ethernet port when the PC’s IP address
falls within the range 169.254.xxx.xxx. PCs that have not been configured for a
specific network default to a “LOCAL LINK” value within the 169.254.xxx.xxx
range.
Note
To comply with industry standards, WorkCentre C2424 systems cannot be
manually configured for IP addresses within the LOCAL LINK range.
Note
Always print the Configuration Page to obtain a record of the system settings
before changing the IP address. After testing the system, be sure to restore the
system’s original network settings.
1.
Connect a crossover cable between the PC and system.
2. Verify the system is “Ready To Print”.
3. Use the system’s control panel to enable AutoIP:
a.
Select the system Setup menu.
b. Select the Connection Setup menu.
c.
Select the Network Setup menu.
d.
Select the TCP/IP Setup menu.
e. Set AutoIP to On.
f.
Exit the menu so the system is “Ready To Print”.
4. Reset the system to cause AutoIP to assign a new IP address (cycle power or
select Restart system from the Shutdown menu).
5.
After the system’s IP address is set, test communication by sending the “PING”
command.
6.
If the test fails, install a different cable and retest.