Xerox Phaser 6180MFP, Руководство по обслуживанию

Страница: 287 / 884

Phaser 6180MFP Multifunction Printer Service Manual 3-99
Error Messages and Codes
Out of Memory/Hard Drive Full
The printer memory is full and cannot continue to print. Print job requires
additional memory. The following troubleshooting procedure applies to these
errors.
Applicable Chain Link
■
Chain Link 016-718 : Out of memory
■
Chain Link 016-982 : Hard Drive Full (Disk Full)
Initial Actions
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■
Image Processor Board, PL9.1.20
■
Memory Card (Option), PL9.1.22
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1. Check the required memory for the
print job.
2. Print a small size file (example as a
Windows test print).
3. Does the error still occur?
Go to step 2. Add memory
card or separate
the print job.
2 1. Reseat the memory card
(page 8-94).
2. Does the error still occur?
Go to step 3. Complete.
3 1. Check the memory card capacity.
Print the printer Configuration Page:
System > Information Pages >
Configuration .
2. Does the memory meet the print job
requirements?
Go to step 4. Replace the
Image
Processor
Board
(page 8-90).
4 1. Replace the memory card
(page 8-94).
2. Does the error still occur?
Replace the
Image
Processor Board
(page 8-90). Complete.