Xerox Phaser 3052, Руководство по обслуживанию

Страница: 46 / 144

June 2014
3-6 Xerox® Phaser® 3020 Printer Service Manual
IQ5, IQ6
Image Quality
IQ5 Low Image Density RAP
The printed image is light, with no ghosting ( Figure 1 ).
Initial Actions
Remove Print Cartridge. Rotate the cartridge 5-6 full rotations to redistribute the toner. Make a
test print.
Check the life of the Print Cartridge, refer to GP 2 Machine Status and Reports. Replace the
Print Cartridge if it has reached end of life.
If the problems continue, follow the procedure.
Procedure
• Switch off the power.
• Clean the contacts on the Print Cartridge and the LVPS / HVPS PWB.
• Switch on the power and make a test print.
The problem continues.
Y
N
Go to SCP 04 Final Actions.
Replace the LVPS / HVPS PWB; PL 3.2 , ( REP 1.6 ).
Figure 1 Light Image
IQ6 Black or Dark Image RAP
The printed image is totally dark or black ( Figure 1 ).
Procedure
WARNING
Do not perform repair activities with the power on or electrical power supplied to the
machine. Some machine components contain dangerous electrical voltages that can
result in electrical shock and possible serious injury.
DANGER: Ne pas effectuer de dépannnage avec le contact principal activé ou avec l'ali-
mentation électrique appliquée à la machine. Certains éléments de la machine compor-
tent des tensions électriques dangereuses qui peuvent causer un choc électrique et de
graves blessures.
AVVERTENZA: Non effettuare alcuna riparazione con l'alimentazione elettrica inserita.
Alcuni componenti contengono corrente ad alta tensione che può provocare forti
scosse e gravi ferite.
VORSICHT: Es dürfen erst Reparaturarbeiten durchgeführt werden, wenn das Gerät aus-
geschaltet ist oder der Netzstecker nicht mehr mit der Stromquelle verbunden ist. Ein-
ige Komponenten des Gerätes sind stromführend und können daher zu ernsthaften
Verletzungen oder Stromschlägen führen.
AVISO: No realice reparaciones con la máquina encendida o conectada a la corriente.
Algunos componentes de la máquina contienen voltajes eléctricos peligrosos que
pueden producir una descarga eléctrica y causar daños graves.
• Switch Off the power.
• Clean the contacts on the Print Cartridge and the LVPS / HVPS PWB.
• Switch on the power and make a test print.
The problem continues.
Y
N
Go to Call Closeout.
• If the image is Black, replace the LVPS / HVPS PWB; PL 3.1 (REP 1.5).
• The Charge Roller is likely defective, replace the Print Cartridge.
Refer to the Xerox® Phaser® 3020 User Guide, Section 6 Maintenance, General Care,
for detailed instructions on how to replace the Print Cartridges.