Xerox DocuPrint 180, Руководство по генерации системы

Страница: 46 / 94

SYSGEN AND SYSGEN-RELATED PROCEDURES
4-18 XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE
6. Enter Y and <ENTER> to allow the
previously entered ID to be changed. Key in
the new ID and press <ENTER>.
NOTE: When you enter no, sysgen will
continue. If you enter yes, you will be able to
change the system ID again.
Enter system ID of up to 30 characters
....*....*....*....*....*....*
System ID IS: xxxxx
Do you want to enter a new system id?
’y’ or ’n’
7.
Enter Y or N and press <ENTER>.
Do you want to save the accounting file?
enter ’y’ or ’n’
8.
Enter Y or N and <ENTER>. A Y and
<ENTER> response causes the change
menu to display. Each time a change is
made, the change question is asked until an
N and <ENTER> is entered, and the sysgen
program continues.
The base configuration and the system configuration
options are displayed followed by:
Do you wish to make any changes? Enter ’y’
or ’n’
>
9.
To discard the changes you just made and
continue sysgen, enter Y.
To save the changes you just made and
continue sysgen, enter N.
Enter Y and <ENTER>.
Do you want to discard the changes you just
made? Enter ’y’ or ’n’>
Is continuation of sysgen required: (y or n)
Should sysgen read from host or tape?
’h’ or ’t’
10. Enter ’t’ and press <ENTER>.
Reading files from tape/host is displayed.
Each file is read from the online channel or tape and placed
on the disk.
Creating file xxxxxx.yyy on drive n
xxxxxx is the system file name,
yyy is the system file type, and
n is the drive ID number that the file is
stored onto.
When sysgen completes, the following message displays:
* Tape rewinding *Sysgen process successful*
* Sysgen program off *
Enter Cmd [’C’ for Menu]>
Table 4-4. Steps to perform an offline update sysgen using
the SYSGEN command (continued)
Step Action System response