Xerox DocuColor 2060, Руководство по устранению неисправностей, Страница: 54 / 60

Resolving printer problems
6-6 Troubleshooting Guide
Tray 4 misfeeds
repeatedly. Paper weight or condition
is inappropriate for tray 4. • Turn the paper stack around or over in the
elevator tray.
• Replace the paper in the tray with paper from
a new package.
• Keep paper in the original wrapper and store
it flat in a dry environment when not in use.
• Fan the paper at all four corners. Change it if
it has uneven edges or if it was not drilled
properly. Fan drilled paper to remove paper
plugs.
• Use papers that are 64 to 220 gsm if
possible. Lightweight or heavyweight paper
may not feed with as much reliability as 64 to
220 gsm paper.
• Remove a few sheets from the top and the
bottom of the ream in the elevator tray.
• If the environment is highly humid (50 to
85%) and you are using coated paper, you
may need to install the tray 4 heater kit.
Paper is loaded
incorrectly. • Ensure that the paper is loaded evenly to the
edge of the tray and not overloaded.
• Check to ensure that the side guides are
lightly against the paper and not too tight.
Misfeeds occur with
lightweight paper. Paper weight is
inappropriate for tray 4. Use a heavier weight paper.
Prints are skewed. Rear and/or side guide
adjustment levers are
incorrectly positioned. Ensure that the rear and side guide adjustment
levers are in the correct position.
Table 6-3. Tray 4 problems
Symptom Probable cause Action