Xerox DocuColor 2060, Дополнительное руководство

Страница: 77 / 216

Printing using Xerox utilities and lpr utilities (DOS and UNIX)
Guide to Submitting Jobs from the Client 3-27
• -C“(res=300)” for models 4050/4090/4850/4890/92C and
2060 only
-C“(res=600)” for 92C NPS/IPS
-C“(res=300)” or -C“(res=600)” for 96/4635/180 NPS/IPS
Specifies the resolution in dots per inch (dpi).
• -C“(sg=<n>)”
Sets the OutputBin attribute to the integer value.
– sg=0 selects stacker group 0 (top tray).
– sg=1 selects stacker group 1.
– sg=2 selects stacker group 2.
NOTE: For more information on the OutputBin attribute, refer
to the Guide to Managing Print Jobs, “Document attributes”
chapter, “Attributes and values” section.
• -C“(<simplex|duplex|tumble>)”
Specifies simplex, duplex, or tumble duplex for the print job.
The default is “simplex.”
Tumble duplex rotates the image 180 degrees on alternate
pages. Both sides of the page are printed but the position of
the image is reversed (from top to bottom) on every other
page.
NOTE: The use of tumble duplex is restricted by certain
characteristics of the PostScript master. If you have difficulty
using this option, contact your Xerox representative for
assistance.
• -C“(size = <n>)”
Specifies the font size in points. This option is valid for ASCII
jobs only.
• -C“(<stitch|staple>)” (for models 4050/4090/4850/4890/92C
only)
Staples the document after it is printed. You can enter either
“stitch” or “staple” to indicate the document is stapled.
Before using this option, verify that the printer to which you
send your document has a stitcher/stacker installed.