Xerox 8080, Руководство по безопасности, Страница: 11 / 20

Safety information
Xerox DocuColor 8080 Digital Press
Safety Guide 7
Operational safety
Your Xerox equipment and supplies were designed and tested to meet strict safety requirements. These include
safety agency examination, approval, and compliance with established environmental standards.
Your attention to the following safety guidelines will help ensure the continued safe operation of your product:
• Use the materials and supplies specifically designed for your product. The use of unsuitable
materials may result in poor performance of the machine and possibly a hazardous situation.
• Follow all warnings and instructions that are marked on or supplied with the machine.
• Place the machine in a room that provides adequate space for ventilation and servicing.
• Place the machine on a level, solid surface (not on a thick pile carpet) that has adequate strength
to support the weight of the machine.
• Do not attempt to move the machine. A leveling device that was lowered when your machine was
installed may damage the carpet or floor.
• Do not set up the machine near a heat source.
• Do not set up the machine in direct sunlight.
• Do not set up the machine in line with the cold air flow from an air conditioning system.
• Do not place containers of coffee or other liquid on the machine.
• Do not block or cover the slots and openings on the machine.
• Do not attempt to override any electrical or mechanical interlock devices.
If you need any additional safety information concerning the machine or materials, contact your Xerox
representative.
Maintenance information
Any operator product maintenance procedures will be described in the user documentation supplied with the
product.
Do not carry out any maintenance on this product which is not described in the customer documentation.
Use the supplies and cleaning materials only as directed in the Operator section of this manual. Keep all
materials out of the reach of children.
Do not remove the covers or guards that are fastened with screws. There are no parts behind these covers that
you can maintain or service.
WARNING:
Be careful when working in areas identified with this warning symbol. These areas may be very
hot and should not be touched.
WARNING:
Do not use aerosol clearners. Aerosol cleaners can be explosive or flammable when used on
electromechanical equipment.