Xerox 6100BD - Phaser Color Laser Printer, Системное руководство

Страница: 87 / 140

Finishing
System Guide 5-3
PCL offset/separator/subset finishing command
The use of the PCL separator command, ESCl1T, in
combination with DocuSP queue defaults enables subset
finishing for PCL jobs. The PCL separator command defines
offset segments of a job. PCL does not commonly support
finishing. However, the use of the PCL separator command
allows offset segments of a job to be finished based on the
finishing default set on the queue. For example, if the queue
default is portrait stitch, all segments of a job where the PCL
separator command has been used will be stitched.
The placement guidelines are as follows:
•
Current Page Offset: If the current page is to be offset
from the previous page, then the PCL separator
command must be placed on the current page before any
image data. Placement should be within the job/page
control section or before.
• Next Page Offset: If the next page in the document is to
be offset from the current page, the PCL separator
command must be placed at the end of the current page
after any image items.
PCL Offset Stacking
Access the Offset stacking switch by opening Printer
Manager and selecting the Stacking tab and then select
[Offset Stacking].
To enable offset stacking for collated or uncollated jobs,
select the enable checkbox. Both buttons are located under
the collated stacking and uncollated stacking sections.
Using the PCL Separator
The following information should be considered when using
the PCL separator command:
•
The offset switch in Printer Manager in the DocuSP
software must be set to ON. If the offset switch is set to
OFF and a job with the PCL separator command is
received, the sets will not offset when the job is printed.
• Multiple uses of the PCL separator command within a job
will be honored.
• Multiple uses of the PCL separator command on a page
will be ignored.
• All finishing limitations and restrictions at the printer will
apply to a subset segment.